PLANET WGSW-52040 - Manual (Page 149)

4-148
Function:
Show information of layer 3 or layer 2 port on the switch
Parameter:
<vlan-id> is the VLAN interface number, the value range from 1 to 4094. <interface-number> is the port number of
the Ethernet, status show important information of all the layer 2 ports. counter {packet | rate} show package
number or rate statistics of all layer 2 ports. <port-channel-number> is the number of the aggregation interface,
<interface-name> is the name of the interface such as port-channel1. [detail] show the detail of the port.
Command Mode:
Admin and Configuration Mode.
Default:
Information not displayed by default
Usage Guide:
While for vlan interfaces, the port MAC address, IP address and the statistic state of the data packet will be shown;
As for Ethernet port, this command will show port speed rate, duplex mode, flow control switch state, broadcast
storm suppression of the port and the statistic state of the data packets; for aggregated port, port speed rate, duplex
mode, flow control switch state, broadcast storm suppression of the port and the statistic state of the data packets
will be displayed. The information of all ports on the switch will be shown if no port is specified.
Using [detail] to show the detail information for ethernet port and port-channel port, the information is related with the
type of switch, board card.
For ethernet port, using status to show important information of all the layer 2 ports by list format. each port is a row,
the showing information include port number, Link, Protocl status, Speed, Duplex, Vlan, port type and port name;
counter packets show package number statistics of all ethernet ports, include layer 2 unicast, broadcast, multicast,
error of input and output redirection package number; counter rate show the rate statistics of all ethernet ports, input
and output package number, byte number in 5 minutes and 5 seconds.
Example:
Show the information of VLAN 1
Switch#show interface vlan 1
Vlan1 is up, line protocol is up, dev index is 2005
Device flag 0x1003(UP BROADCAST MULTICAST)
IPv4 address is:
192.168.10.1 255.255.255.0 (Primary)
Hardware is EtherSVI, address is 00-00-00-00-00-01
MTU is 1500 bytes , BW is 0 Kbit
Encapsulation ARPA, loopback not set