PLANET WGSW-52040 - Manual (Page 789)

53-329
53.21 ulpp flush disable arp
Command:
ulpp flush disable arp
Function:
Disable receiving the flush packets of deleting ARP.
Parameter:
None.
Default:
By default, disable receiving the flush packets of deleting ARP.
Command mode:
Port mode.
Usage Guide:
If this command is configured, then it will not receive the flush packets of deleting ARP.
Example:
Disable receiving the flush packets of deleting ARP.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp flush disable arp
53.22 ulpp flush disable mac
Command:
ulpp flush disable mac
Function:
Disable receiving the flush packets of updating MAC address.
Parameter:
None.
Default:
By default, disable receiving the flush packets of updating MAC address.