PLANET WGSW-52040 - Manual (Page 134)

3-133
3.15 show cluster members
Command:
show cluster members [id <member-id> | mac-address <mac-addr>]
Function:
Display member information of a cluster. This command can only apply to commander switches.
Parameters:
member-id: member id of the switch.
mac-addr: the CPU mac addresses of member switches.
Default:
No parameters means to display information of all member switches.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Executing this command on a commander switch will display the configuration information of all cluster member
switches.
Example:
Execute this command on a commander switch to display the configuration information of all and specified cluster
member switches.
Switch#show cluster members
Switch#show cluster members id 1
3.16 show cluster candidates
Command:
show cluster candidates [nodes-sn <candidate-sn-list> | mac-address <mac-addr>]
Function:
Display the statistic information of the candidate member switches on the command switch