PLANET WGSW-52040 - Manual (Page 72)

1-71
Command:
authentication securityip <ip-addr>
no authentication securityip <ip-addr>
Function:
To configure the trusted IP address for Telnet and HTTP login method. The no form of this command will remove the
trusted IP address configuration.
Parameters:
<ip-addr> is the trusted IP address of the client in dotted decimal format which can login the switch.
Default:
No trusted IP address is configured by default.
Command Mode:
Global Mode.
Usage Guide:
IP address of the client which can login the switch is not restricted before the trusted IP address is not configured.
After the trusted IP address is configured, only clients with trusted IP addresses are able to login the switch. Up to 32
trusted IP addresses can be configured in the switch.
Example:
To configure 192.168.1.21 as the trusted IP address.
Switch(config)# authentication securityip 192.168.1.21
1.2.9 authentication securityipv6
Command:
authentication securityipv6 <ipv6-addr>
no authentication securityipv6 <ipv6-addr>
Function:
To configure the security IPv6 address for Telnet and HTTP login method. The no form of this command will remove
the specified configuration.
Parameters: