PLANET WGSW-52040 - Manual (Page 701)

46-241
46.2 ipv6 security-ra enable
Command:
ipv6 security-ra enable
no ipv6 security-ra enable
Function:
Enable IPv6 security RA on a port, causing this port not to forward the received RA message. The no ipv6
security-ra enable will disable the IPv6 security RA on a port.
Parameters:
None.
Command Mode:
Port Configuration Mode.
Default:
IPv6 security RA function is disabled by default.
Usage Guide:
Only after globally enabling the security RA function, can the security RA on a port be enabled. Globally disabling
security RA will clear all the configured security RA ports.
Example:
Enable IPv6 security RA on a port.
Switch(Config-If-Ethernet1/2)#ipv6 security-ra enable
46.3 show ipv6 security-ra
Command:
show ipv6 security-ra [interface <interface-list>]
Function:
Display all the interfaces with IPv6 RA function enabled.
Parameters:
No parameter will display all distrust ports, entering a parameter will display the corresponding distrust port.