PLANET WGSW-52040 - Manual (Page 223)

11-222
the reset of OAM function
OAM_local_link-fault The number of the local link-fault faults
OAM_local_dying gasp The number of the local dying-gasp faults
OAM_local_critical event The number of the local critical-event faults
11.26 show ethernet-oam link-events configuration
Command:
show ethernet-oam link-events configuration [interface {ethernet | } <IFNAME>]
Function:
Show configuration of link events on specified or all ports with OAM enabled, including detection period and
threshold of the events and so on.
Parameters:
<IFNAME>, the port that the statistic information of OAM link events needs to be shown, the statistic information of
OAM link events for all ports will be shown if this parameter is not specified.
Command Mode:
Admin mode
Default:
N/A.
Usage Guide:
N/A.
Example:
Show configuration of link events on ethernet 1/1.
Switch#show ethernet-oam link-events configuration interface ethernet 1/1
Ethernet1/1 link-monitor configuration：
event high-threshold low-threshold window(200ms)
----------------------------------------------------------------------------------------------------
Err-symbol-Period none 1 2
Err-frame-Period none 1 10
Err-frame none 2 5
Err-frame-second-summary none 2 600