PLANET WGSW-52040 - Manual (Page 855)

63-395
Usage Guide:
After implementing this command, the booting sequence of IMG files in the corresponding storage device, which
IMG file is currently used in booting, the configuration information of the CFG file in the storage device and the CFG
file currently booted.
Example:
Display the first and second IMG files and the CFG file enabled by switch.
Switch#show boot-files
Booted files on switch
The primary img file at the next boot time: flash:/nos.img
The backup img file at the next boot time: flash:/nos.img
Current booted img file: flash:/nos.img
The startup-config file at the next boot time: flash:/startup.cfg
Current booted startup-config file: flash:/startup.cfg
If the CFG file of the next booting is set as NULL, the CFG part mentioned above will be displayed as follows:
The startup-config file at the next boot time: NULL
Current booted startup-config file: flash:/startup.cfg
63.10 show debugging
Command:
show debugging {l4 | l4drv | lldp | nsm | other | spanning-tree}
Function:
Display the debug switch status.
Usage Guide:
If the user needs to check what debug switches have been enabled, show debugging command can be executed.
Command mode:
Admin Mode
Example:
Check for currently nsm debug switch state.
Switch#show debugging nsm
NSM debugging status