PLANET WGSW-52040 - Manual (Page 187)

8-186
Display all ports with lldp debug enabled.
Switch(config)#show debugging lldp
====BEGINNING OF LLDP DEBUG SETTINGS====
debug lldp
debug lldp packets interface Ethernet1/1
debug lldp packets interface Ethernet1/2
debug lldp packets interface Ethernet1/3
debug lldp packets interface Ethernet1/4
debug lldp packets interface Ethernet1/5
=============END OF DEBUG SETTINGS===============
8.16 show lldp
Command:
show lldp
Function:
Display the configuration information of global LLDP, such as the list of all the ports with LLDP enabled, the interval
of sending update messages, the configuration of aging time, the interval needed by the sending module to wait for
re-initialization, the interval of sending TRAP, the limitation of the number of the entries in the Remote Table.
Parameters:
None.
Default:
Do not display the configuration information of global LLDP.
Command Mode:
Admin Mode, Global Mode.
Usage Guide:
Users can check all the configuration information of global LLDP by using “show lldp”.
Example:
Check the configuration information of global LLDP after it is enabled on the switch.
Switch(config)#show lldp
-----LLDP GLOBAL INFORMATIONS-----