PLANET WGSW-52040 - Manual (Page 781)

53-321
Disable.
Command mode:
ULPP group configuration mode.
Usage Guide:
If configure this command, when the link is switched, it will not actively send the flush packets to notify the upstream
device to delete the dynamic unicast mac according to vlan.
Example:
Disable sending the flush packets deleted by mac-vlan.
Switch(config)#ulpp group 1
Switch(ulpp-group-1)#flush disable mac-vlan
53.11 flush enable arp
Command:
flush enable arp
Function:
Enable sending the flush packets of deleting ARP.
Parameter:
None.
Default:
By default, enable sending the flush packets of deleting ARP.
Command mode:
ULPP group configuration mode.
Usage Guide:
If enable this function, when the link is switched, it will actively send the flush packets to notify the upstream device,
so as to delete the list entries of ARP.
Example:
Enable sending the flush packets of deleting ARP.
Switch(config)# ulpp group 20