PLANET WGSW-52040 - Manual (Page 216)

11-215
11.23 ethernet-oam timeout
Command:
ethernet-oam timeout <seconds>
no ethernet-oam timeout
Function:
Configure the timeout of OAM connection, no command restores the default value.
Parameters:
<seconds>, the timeout ranging from 5 to 10 seconds.
Command Mode:
Port mode
Default:
5s.
Usage Guide:
OAM connection will be disconnected if no OAMPDU is received after specified timeout.
Example:
Set the timeout of OAM connection for ethernet 1/4 to be 6 seconds.
Switch(Config-If-Ethernet1/4)#ethernet-oam timeout 6
11.24 show ethernet-oam
Command:
show ethernet-oam [{local | remote} interface {ethernet |} <IFNAME>]
Function:
Show Ethernet OAM connection of specified or all ports.
Parameters:
Overview information of all Ethernet OAM connections will be shown if no parameters is input
local, show detailed information of local OAM connection
remote, show detailed information of remote OAM connection
<IFNAME>, the port that OAM connection information will be shown
Command Mode: