PLANET WGSW-52040 - Manual (Page 54)

1-53
line with the parameter, it should fill in the parameter which is able to be selected discretionarily according to the
required format. However, level of the no command is able to be set optionally and it does not affect the result. When
using no command, LINE must be the configured command line. If the command line with the parameter, the
parameter must be matched with the configured command.
Example:
Change the level of show ip route command to level 5.
Switch(config)#privilege exec level 5 show ip route
Change the level of peer A.B.C.D command to level 6.
Switch(config)#privilege router-msdp level 6 peer 1.2.3.4
Restore the original level for show ip route command.
Switch(config)#no privilege exec level 5 show ip route
Restore the original level for peer A.B.C.D command.
Switch(config)#no privilege router-msdp level 6 peer 1.2.3.4
1.1.23 reload
Command:
Reload
Function:
Warm reset the switch.
Command mode:
Admin Mode.
Usage Guide:
The user can use this command to restart the switch without power off.
1.1.24 service password-encryption
Command:
service password-encryption
no service password-encryption
Function: