PLANET WGSW-52040 - Manual (Page 609)

38-149
No access list is configured by default.
Usage Guide:
When this command is issued for the first time, an empty access list will be created.
Example:
To create a standard IP access list name ipFlow.
Switch(config)#ip access-list standard ipFlow
38.12 ipv6 access-list
Command:
ipv6 access-list <num-std> {deny | permit} {<sIPv6Prefix/sPrefixlen> | any-source | {host-source
<sIPv6Addr>}}
no ipv6 access-list <num-std>
Functions:
Creates a numbered standard IP access-list, if the access-list already exists, then a rule will add to the current
access-list; the “no access-list {<num-std>|<num-ext>} “command deletes a numbered standard IP access-list.
Parameters:
<num-std> is the list number, list range is between 500～599; <sIPv6Prefix> is the prefix of the ipv6 source address;
<sPrefixlen> is the length of prefix of the ipv6 source address, range is between 1～128; <sIPv6Addr> is the ipv6
source address.
Command Mode:
Global Mode.
Default:
No access-list configured.
Usage Guide:
Creates a numbered 520 standard IP access-list first time, the following configuration will add to the current
access-list.
Examples:
Creates a numbered 520 standard IP access-list, allow the source packet from 2003:1:2:3::1/64 pass through the net,
and deny all the other packet from the source address 2003:1:2::1/48 pass through.
Switch (config)#ipv6 access-list 520 permit 2003:1:2:3::1/64