PLANET WGSW-52040 - Manual (Page 793)

53-333
Switch(config-if-ethernet1/2)#ulpp flush enable mac-vlan
53.27 ulpp group
Command:
ulpp group <integer>
no ulpp group <integer>
Function:
Create a ULPP group. If this group exists, then enter the configuration mode of ULPP group. The no command
deletes a ULPP group.
Parameter:
<integer> is the ID of ULPP group, range from 1 to 48.
Command mode:
Global Mode.
Default:
Any ULPP groups are not configured.
Usage Guide:
None.
Example:
Configure ulpp group 20 or enter the mode of ulpp group 20.
Switch(config)# ulpp group 20
Switch(ulpp-group-20)#
53.28 ulpp group master
Command:
ulpp group <integer> master
no ulpp group <integer> master