PLANET WGSW-52040 - Manual (Page 596)

37-136
no multicast-vlan association <vlan-list>
Function:
Associate several VLANs with a multicast VLAN; the “no” form of this command cancels the association relations.
Parameter:
<vlan-list> the VLAN ID list associated with multicast VLAN. Each VLAN can only be associated with one multicast
VLAN and the association will only succeed when every VLAN listed in the VLAN ID table exists.
Command Mode:
VLAN Mode.
Default:
The multicast VLAN is not associated with any VLAN by default.
Usage Guide:
After a VLAN is associated with the multicast VLAN, when there comes the multicast order in the port of this VLAN,
then the multicast data will be sent from the multicast VLAN to this port, so to reduce the data traffic. The VLAN
associated with the multicast VLAN should not be a Private VLAN. A VLAN can only be associated with another
VLAN after the multicast VLAN is enabled. Only one multicast VLAN can be enabled on a switch.
Examples:
Switch(config)#vlan 2
Switch(Config-Vlan2)# multicast-vlan association 3, 4
37.3 multicast-vlan association interface
Command:
multicast-vlan association interface (ethernet | port-channel|) IFNAME
no multicast-vlan association interface (ethernet | port-channel|) IFNAME
Function:
Associate the specified port with the multicast VLAN, so the associated ports are able to receive the multicast
flow. The no command cancels the association between the ports and the multicast VLAN.
Parameter:
IFNAME: The name of the ethernet port or port-channel port