PLANET WGSW-52040 - Manual (Page 47)

1-46
Function:
Configure the timeout of exiting admin mode. The “no exec-timeout” command restores the default value.
Parameters:
<minute> is the time value shown in minute and ranges between 0~35791. <seconds> is the time value shown in
seconds and ranges between 0~59.
Command mode:
Global mode
Default:
Default timeout is 10 minutes.
Usage guide:
To secure the switch, as well to prevent malicious actions from unauthorized user, the time will be count from the last
configuration the admin had made, and the system will exit the admin mode at due time. It is required to enter admin
code and password to enter the admin mode again. The timeout timer will be disabled when the timeout is set to 0.
Example:
Set the admin mode timeout value to 6 minutes.
Switch(config)#exec-timeout 6
Set the admin mode timeout value to 5 minutes, 30 seconds.
Switch(config)#exec-timeout 5 30
1.1.13 exit
Command:
Exit
Function:
Quit current mode and return to its previous mode.
Command mode:
All Modes
Usage Guide:
This command is to quit current mode and return to its previous mode.