PLANET WGSW-52040 - Manual (Page 368)

20-137
Function:
The non-aggregation policy command supporting three colors. Determine whether the working mode of token bucket
is singe rage single bucket, single rate dual bucket or dual rate dual bucket, set the corresponding action to the
different color packets. The no command will delete the mode configuration.
Parameters:
bits_per_second: The committed information rate – CIR (Committed Information Rate), in Kbps, ranging from 1 to
10000000;
normal_burst_bytes: The committed burst size – CBS (Committed Burst Size), in byte, ranging from 1 to 1000000.
When the configured CBS value exceeds the max limit of the chip, configure the hardware with max number
supported by the chip without any CLI prompt; maximum_burst_bytes: The peak burst size – PBS (Peak Burst
Size), in byte, ranging from 1 to 10000000. When the configured PBS value exceeds the max limit of the chip,
configure the hardware with max number supported by the chip without any CLI prompt. Notice: this configuration
only exists in dual bucket mode;
pir peak_rate_bps: The peak information rate – PIR (Peak Information Rate), in kbps, ranging from 1 to 10000000.
Without configuring PIR, the Police works in the single rate dual bucket mode; otherwise in the dual rate dual bucket
mode. Notice: this configuration only exists in dual bucket mode;
violate-action: The actions to take when the PIR is exceeded, which means the messages are red, the
default as drop;
conform-action: The action to take when the CIR is not exceeded, which means the messages are green, the
default as transmit;
exceed-action: The actions to take when the CIR is exceeded but PIR isn’t, which means the messages are yellow,
the default as drop.
ACTION include:
drop/transmit: Drop/transmit the packets
set-dscp-transmit sets DSCP, it is valid to IPv4 and IPv6 packets, only set-dscp-transmit or set-prec-transmit can be
selected.
set-prec-transmit sets TOS, only set-prec-transmit or set-dscp-transmit can be selected
set-internal-priority sets the internal priority of the packets
set-Drop-Precedence sets the drop precedence of the packets
set-cos-transmit sets the CoS value of the L2 packets
Default:
No policy action; the default action of conform-action is transmit, while that of exceed-action and violate-action are
both drop.
Command mode: