PLANET WGSW-52040 - Manual (Page 391)

23-2
Display routing table.
Parameter:
database is database information.
Command Mode:
Admin Mode
Usage Guide:
Show kernal routing table, include: routing type, destination network, mask, next-hop address, interface, etc.
Example:
Switch#show ip route
Codes: C - connected, S - static, R - RIP derived, O - OSPF derived
A - OSPF ASE, B - BGP derived
Destination Mask Nexthop Interface Pref
C 2.2.2.0 255.255.255.0 0.0.0.0 vlan2 0
C 4.4.4.0 255.255.255.0 0.0.0.0 vlan4 0
S 6.6.6.0 255.255.255.0 9.9.9.9 vlan9 1
Displayed information Explanation
C –connected Direct route, namely the segment directly
connected with the layer 3 switch
S –static Static route, the route manually configured by
users
R - RIP derived RIP route, acquired by layer 3 switch through the
RIP protocol.
O - OSPF derived OSPF route, acquired by layer 3 switch through the
OSPF protocol
A- OSPF ASE Route introduced by OSPF
B- BGP derived BGP route, acquired by the BGP protocol.
Destination Target network
Mask Target network mask
Nexthop Next-hop IP address
Interface Next-hop pass-by layer 3 swtich interfaces
Preference Route priority. If other types of route to the target
network exists, the kernel route will only shows
those with high priority.