PLANET WGSW-52040 - Manual (Page 383)

21-152
Chapter 21 Commands for
Flow-based Redirection
21.1 access-group redirect to interface ethernet
Command:
access-group <aclname> redirect to interface [ethernet <IFNAME> | <IFNAME>]
no access-group <aclname> redirect
Function:
Specify flow-based redirection; “no access-group <aclname> redirect” command is used to delete flow-based
redirection.
Parameters:
<aclname> name of the flow , only supports digital standard IP ACL, digital extensive IP ACL, nomenclatural
standard IP ACL, nomenclatural extensive IP ACL, digital standard MAC ACL, digital extensive MAC ACL,
nomenclatural standard MAC ACL, nomenclatural extensive MAC ACL, digital standard IPv6 ACL, and
nomenclatural standard IPv6 ACL. Parameters of Timerange and Portrange can not be set in ACL; the type of ACL
should be Permit. <IFNAME> the destination port of redirection.
Command Mode:
Physical Port Configuration Mode.
Usage Guide:
“no access-group <aclname> redirect” command is used to delete flow-based redirection. Flow-based redirection
function enables the switch to transmit the data frames meeting some special condition to another specified port.
Examples:
Redirecting the frames whose source IP is 192.168.1.111 received from port 1 to port 6,
Switch(config)#access-list 1 permit host 192.168.1.111
Switch(config)# interface ethernet 1/1
Switch(Config-If-Ethernet1/1)# access-group 1 redirect to interface ethernet 1/6