PLANET WGSW-52040 - Manual (Page 291)

17-60
Switch(config)#interface ethernet 1/5
Switch(Config-If-Ethernet1/5)# switchport mode trunk
17.2.2 show vlan-translation n-to-1
Command:
show vlan-translation n-to-1 [<interface-name>]
Function:
Show the port configuration with Multi-to-One VLAN translation.
Parameter:
interface-name: Specify the name of the port which will be shown. If there is no parameter, show all port
configurations with this function.
Command Mode:
Admin mode.
Default:
There is no Multi-to-One VLAN translation information.
Usage Guide:
When it is
Example:
Show all port configurations with Multi-to-One VLAN translation function.
Switch# show vlan-translation n-to-1
Interface Ethernet1/1:
vlan-translation n-to-1 enable, vlan 1-4 to 100
vlan-translation n-to-1 enable,vlan 5-8;13 to 101
Interface Ethernet1/2:
vlan-translation n-to-1 enable,vlan 1-4 to 100