PLANET WGSW-52040 - Manual (Page 293)

17-62
Parameter:
None.
Command Mode:
Global Mode.
Default:
MAC-based VLAN is preferred by default.
Usage Guide:
Configure the preference of dynamic-vlan on switch. The default priority sequence is MAC-based VLAN 、
IP-subnet-based VLAN、Protocol-based VLAN, namely the preferred order when several dynamic VLAN is available.
This command is used to set to preferring the IP-subnet-based VLAN.
Example:
Set the IP-subnet-based VLAN preferred.
Switch#config
Switch(config)#dynamic-vlan subnet-vlan prefer
17.3.3 mac-vlan
Command:
mac-vlan mac <mac-addrss> vlan <vlan-id> priority <priority-id>
no mac-vlan {mac <mac-addrss>|all}
Function:
Add the correspondence between MAC address and VLAN, namely specify certain MAC address to join specified
VLAN. The no form of this command deletes all/the correspondence.
Parameter:
mac-address is the MAC address which is shown in the form of XX-XX-XX-XX-XX-XX, vlan-id is the ID of the VLAN
with a valid range of 1~4094; priority-id is the level of priority and is used in the VLAN tag with a valid range of 0~7;
all refers to all the MAC addresses.
Command Mode:
Global Mode.