PLANET WGSW-52040 - Manual (Page 211)

11-210
Configure the high threshold of errored symbol event, no command restores the default value.
Parameters:
<high-symbols>, the high detection threshold of errored symbol event, ranging from 2 to 18446744073709551615
symbols.
none, cancel the high threshold configuration.
Command Mode:
Port mode
Default:
none.
Usage Guide:
During the specific detection period, serious link event is induced if the number of errored symbols is larger than or
equal to the high threshold and the device notifies the peer by sending Information OAMPDU of which the value of
Link Fault flag in Flags field is 1. Note that the high threshold should not be less than the low threshold.
Example:
Set the high threshold of errored symbol event on port 1/4 to none.
Switch(Config-If-Ethernet1/4)#ethernet-oam errored-symbol-period threshold high none
11.17 ethernet-oam errored-symbol-period threshold low
Command:
ethernet-oam errored-symbol-period threshold low <low-symbols>
no ethernet-oam errored-symbol-period threshold low
Function:
Configure the low threshold of errored symbol event, no command restores the default value.
Parameters:
<low-symbols>, the low threshold of errored symbol event, ranging from 1 to 18446744073709551615 symbols.
none, cancel the high threshold configuration.
Command Mode:
Port mode