PLANET WGSW-52040 - Manual (Page 868)

63-408
Admin Mode
Usage Guide:
Use this command to view the version information for the switch, including hardware version and software version.
Example:
Switch#show version
63.29 traceroute
Command:
traceroute [source <ipv4-addr> ] { <ip-addr> | host <hostname> } [hops <hops> ] [timeout <timeout> ]
Function:
This command is tests the gateway passed in the route of a packet from the source device to the target device. This
can be used to test connectivity and locate a failed sector.
Parameter:
<ipv4-addr> is the assigned source host IPv4 address in dot decimal format. <ip-addr> is the target host IP address
in dot decimal format. <hostname> is the hostname for the remote host. <hops> is the maximum gateway number
allowed by Traceroute command. <timeout> Is the timeout value for test packets in milliseconds, between 100
-10000.
Default:
The default maximum gateway number is 30, timeout in 2000 ms.
Command mode:
Admin Mode
Usage Guide:
Traceroute is usually used to locate the problem for unreachable network nodes.
63.30 traceroute6
Command: