10 uldp hello-interval, Uldp hello, Interval – PLANET WGSW-52040 User Manual
Page 172
7-171
Global Configuration Mode and Port Configuration Mode.
Default:
By default ULDP is not configured.
Usage Guide:
When ULDP is disabled globally, then ULDP in all the ports will be disabled.
Example:
To disable the ULDP configuration in global configuration mode.
Switch(config)#uldp disable
7.10 uldp hello-interval
Command:
uldp hello-interval <integer>
no uldp hello-interval
Function:
To configure the interval for ULDP to send hello messages. The no form of this command will restore the default
interval for the hello messages.
Parameters:
<integer>: The interval for the Hello messages, with its value limited between 5 and 100 seconds, 10 seconds by
default.
Command Mode:
Global Configuration Mode.
Default:
10 seconds by default.
Usage Guide:
Interval for hello messages can be configured only if ULDP is enabled globally, its value limited between 5 and 100
seconds.
Example:
To configure the interval of Hello messages to be 12 seconds.