PLANET WGSW-52040 - Manual (Page 656)

40-196
Set the timeout value of quering dynamic MAC as 30 seconds.
Switch(config)#mac-address query timeout 30
40.10 show arp-dynamic count
Command:
show arp-dynamic count {(vlan <1-4096>)| interface ethernet <portName>}
Function:
Display the number of dynamic ARP of corresponding port and VLAN.
Parameters:
<vlan-id> is the specified vlan ID.
<portName> is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Use this command to display the number of dynamic ARP of corresponding port and VLAN.
Examples:
Display the number of dynamic ARP of the port and VLAN which are configured with number limitation function of
ARP.
Switch(config)# show arp-dynamic count interface ethernet 1/3
Port MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3 5 1
-----------------------------------------------------------------------------------------------------
Switch(config)# show arp-dynamic count vlan 1
Vlan MaxCount CurrentCount
-----------------------------------------------------------------------------------------------------
1 55 15
-----------------------------------------------------------------------------------------------------