PLANET WGSW-52040 - Manual (Page 587)

36-127
Set the static mrouter port of the VLAN; the “no” form of this command cancels the configuration.
Parameter:
vlan-id: VLAN id, the valid range is<1-4094>
Ehternet: name of Ethernet port
Ifname: Name of interface
port-channel: port aggregate
Command Mode:
Global Mode
Default:
When a port is made static and dynamic mrouter port at the same time, it’s the static mrouter properties is preferred.
Deleting the static mrouter port can only be done with the “no” form of this command.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrouter-port interface ethernet1/13
36.1.10 ipv6 mld snooping vlan mrouter-port learnpim6
Command:
ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6
no ipv6 mld snooping vlan <vlan-id> mrouter-port learnpim6
Function:
Enable the function that the specified VLAN learns mrouter-port (according to pimv6 packets), the no command will
disable the function.
Parameter:
<vlan-id>: The specified VLAN ID, ranging from 1 to 4094.
Command Mode:
Global Mode
Default:
Enable
Usage Guide: