PLANET WGSW-52040 - Manual (Page 788)

53-328
Control VLAN:1
Protected VLAN: Reference Instance 1
Member Role State
--------------------------------------------------------------
Ethernet1/1 MASTER FORWARDING
Ethernet1/2 SLAVE STANDBY
53.20 ulpp control vlan
Command:
ulpp control vlan <vlan-list>
no ulpp control vlan <vlan-list>
Function:
Configure the receiving control VLANs of the port, the no command restores the default value.
Parameter:
<vlan-list> specify the control VLAN list that receives the flush packets, such as: i; j-k. The number of VLANs in
Each character string can not exceed 100. The receiving control VLAN of the port can be added.
Default:
The default is VLAN 1.
Command mode:
Port mode.
Usage Guide:
Configure the receiving control VLAN for the port. This VLAN must correspond the existent VLAN, after it is
configured, this VLAN can’t be deleted.
Example:
Configure the receiving control VLAN as 10.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp control vlan 10