PLANET WGSW-52040 - Manual (Page 59)

1-58
1.1.31 show cpu usage
Command:
show cpu usage [<slotno>]
Function:
Show CPU usage rate.
Command mode:
Admin and configuration mode.
Usage Guide:
Check the current usage of CPU resource by show cpu usage command. Only the chassis switch uses slotno
parameter which is used to show the CPU usage rate of the card on specified slot, if there is no parameter, the
default is current card.
Example:
Show the current usage rate of CPU.
Switch#show cpu usage
Last 5 second CPU IDLE: 87%
Last 30 second CPU IDLE: 89%
Last 5 minute CPU IDLE: 89%
From running CPU IDLE: 89%
1.1.32 show cpu utilization
Command:
show cpu utilization
Function:
Show the current CPU utilization rate.
Parameter:
None.
Default:
None.