PLANET WGSW-52040 - Manual (Page 171)

7-170
7.8 uldp enable
Command:
uldp enable
Function:
ULDP will be enabled after issuing this command. In global configuration mode, this command will enable ULDP for
the global. In port configuration mode, this command will enable ULDP for the port.
Parameters:
None.
Command Mode:
Global Configuration Mode and Port Configuration Mode.
Default:
By default ULDP is not configured.
Usage Guide:
ULDP can be configured for the ports only if ULDP is enabled globally. If ULDP is enabled globally, it will be effect for
all the existing fiber ports. For copper ports and fiber ports which are available after ULDP is enabled, this command
should be issued in the port configuration mode to make ULDP be effect.
Example:
Enable ULDP in global configuration mode.
Switch(config)#uldp enable
7.9 uldp disable
Command:
uldp disable
Function:
To disable ULDP configuration through this command.
Parameters:
None.
Command Mode: