PLANET WGSW-52040 - Manual (Page 451)

28-62
If client node type is to be specified, it is recommended to set the client node type to h-node that broadcasts after
point-to-point communication.
Example:
Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node
28.1.25 network-address
Command:
network-address <network-number> [<mask> | <prefix-length>]
no network-address
Function:
Sets the scope for assignment for addresses in the pool; the “no network-address” command cancels the setting.
Parameters:
<network-number> is the network number; <mask> is the subnet mask in the decimal format; <prefix-length>
stands for mask in prefix form. For example, mask 255.255.255.0 in prefix is “24”, and mask 255.255.255.252 in
prefix is “30”. Note: When using DHCP server, the pool mask should be longer or equal to that of layer 3 interface IP
address in the corresponding segment.
Default:
If no mask is specified, default mask will be assigned according to the address class.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command sets the scope of addresses that can be used for dynamic assignment by the DHCP server; one
address pool can only have one corresponding segment. This command is exclusive with the manual address
binding command “hardware address” and “host”.
Example:
Configuring the assignable address in pool 1 to be 10.1.128.0/24.
Switch(dhcp-1-config)#network-address 10.1.128.0 24