PLANET WGSW-52040 - Manual (Page 811)

57-351
Chapter 57 Commands for RSPAN
Configuration
57.1 remote-span
Command:
remote-span
no remote-span
Function:
To configure VLAN to RSPAN VLAN. The no form of this command will delete the RSPAN VLAN.
Parameter:
None.
Command Mode:
VLAN Configuration Mode.
Default:
Not configured.
Usage Guide:
This command is used to configure the existing VLAN as RSPAN VLAN. Dedicated RSPAN VLAN should be
configured before RSPAN can function. When configuring RSPAN VLAN, it should be made sure that specialized
VLAN, such as the default VLAN, dynamic VLAN, private VLAN, multicast VLAN, and layer 3 interface enabled
VLAN, should not be configured as RSPAN VLAN. If any existing sessions are still working when RSPAN is disabled,
these sessions will be still working regardless the configuration change. However, if any layer 3 interface is configure
in the VLAN after RSPAN is disable, the existing RSPAN session will be stopped.
Example:
Switch(Config-Vlan5)#remote-span