PLANET WGSW-52040 - Manual (Page 850)

63-390
Command Mode:
Global mode.
Default:
Disable state.
Usage Guide:
After enable this command, the commands executed by user at the console, telnet or ssh terminal will record the log,
so it should be used with the logging LOGHOST command.
Example:
Enable the command and send the commands executed by user into log host (10.1.1.1)
Switch(Config)#logging 10.1.1.1
Switch(Config)#logging executed-commands enable
63.6 logging loghost sequence-number
Command:
logging loghost sequence-number
no logging loghost sequence-number
Function:
Add the loghost sequence-number for the log; the no command does not include the loghost sequence-number.
Command Mode:
Port mode
Default:
Do not include the sequence-number.
Usage Guide:
Use logging command to configure the loghost before this command is set.
Example:
Open the loghost sequence-number.
Switch(config)# logging loghost sequence-number