PLANET WGSW-52040 - Manual (Page 682)

44-222
44.8 debug aaa error
Command:
debug aaa error
no debug error
Function:
Enable the debug information of aaa about errors; the no operation of this command will disable that debug
information.
Parameters:
None.
Command Mode:
Admin Mode.
Usage Guide:
By enabling the debug information of aaa about errors, users can check the information of all kinds of errors that
occurs in the operation process of Radius protocol, which might help diagnose the cause of faults if there is any.
Example:
Enable the debug information of aaa about errors.
Switch#debug aaa error
44.9 radius nas-ipv4
Command:
radius nas-ipv4 <ip-address>
no radius nas-ipv4
Function:
Configure the source IP address for RADIUS packet sent by the switch. The “no radius nas-ipv4” command deletes
the configuration.
Parameter:
<ip-address> is the source IP address of the RADIUS packet, in dotted decimal notation, it must be a valid unicast
IP address.