PLANET WGSW-52040 - Manual (Page 524)

33-64
checking binding data and executing port action and so on.
33.3 debug ip dhcp snooping packet
Command:
debug ip dhcp snooping packet
no debug ip dhcp snooping packet
Function:
This command is used to enable the DHCP SNOOPING debug switch to debug the message-processing procedure
of DHCP SNOOPING.
Command Mode:
Admin Mode.
Usage Guide:
The debug information that the DHCP SNOOPING is processing messages, including every step in the
message-processing procedure: adding alarm information, adding binding information, transmitting DHCP
messages, adding/peeling option 82 and etc.
33.4 debug ip dhcp snooping packet interface
Command:
debug ip dhcp snooping packet interface {[ethernet] <InterfaceName>}
no debug ip dhcp snooping packet {[ethernet] <InterfaceName>} Function: This command is used to enable
the DHCP SNOOPING debug switch to debug the information that DHCP SNOOPING is receiving a packet.
Parameters:
<InterfaceName>: Interface name.
Command Mode:
Admin Mode.
Usage Guide:
The information that DHCP Snooping is receiving messages from a specific port.