PLANET WGSW-52040 - Manual (Page 183)

8-182
Usage Guide:
When the Remote MIB is full, Discard means to discard the received message; Delete means to the message with
the least TTL in the Remoter Table.
Example:
Set port ethernet 1/5 of the switch as delete.
Switch(config)#in ethernet 1/5
Switch(Config-If-Ethernet1/5)#lldp tooManyNeighbors delete
8.11 lldp transmit delay
Command:
lldp transmit delay <seconds>
no lldp transmit delay
Function:
Since local information might change frequently because of the variability of the network environment, there could be
many update messages sent in a short time. So a delay is required to guarantee an accurate statistics of local
information.
When transmit delay is the default value and tx-interval is configured via some commands, transmit delay will
become one fourth of the latter, instead of the default 2.
Parameters:
<seconds>is the time interval, ranging from 1 to 8192 seconds.
Default:
The interval is 2 seconds by default.
Command Mode:
Global Mode.
Usage Guide:
When the messages are being sent continuously, a sending delay is set to prevent the Remote information from
being updated repeatedly due to sending messages simultaneously.
Example: