PLANET WGSW-52040 - Manual (Page 176)

8-175
Chapter 8 Commands for LLDP
Function
8.1 clear lldp remote-table
Command:
clear lldp remote-table
Function:
Clear the Remote-table on the port.
Parameters:
None.
Default:
Do not clear the entries.
Command Mode:
Port Configuration Mode.
Usage Guide:
Clear the Remote table entries on this port.
Example:
Clear the Remote table entries on this port.
Switch(Config-If-Ethernet 1/1)# clear lldp remote-table
8.2 debug lldp
Command:
debug lldp
no debug lldp
Function:
Enable the debug information of LLDP function, the no operation of this command will disable the debug