PLANET WGSW-52040 - Manual (Page 588)

36-128
Enable the function that the specified VLAN learns mrouter-port (according to pimv6 packets). After a port received
pimv6 packets, it will be set to mrouter port for implementing the automatic learning.
Example:
Disable the function that vlan 100 learns mrouter-port (according to pimv6 packets).
Switch(config)#no ipv6 mld snooping vlan 100 mrouter-port learnpim6
36.1.11 ipv6 mld snooping vlan mrpt
Command:
ipv6 mld snooping vlan <vlan-id> mrpt <value>
no ipv6 mld snooping vlan <vlan-id> mrpt
Function:
Configure the keep-alive time of the mrouter port.
Parameter:
vlan-id: VLAN ID, the valid range is <1-4094>
value: mrouter port keep-alive time with a valid range of <1-65535> secs.
Command Mode:
Global Mode
Default:
255s
Usage Guide:
This configuration is applicable on dynamic mrouter port, but not on static mrouter port. To use this command, MLD
snooping must be enabled on the VLAN.
Example:
Switch(config)#ipv6 mld snooping vlan 2 mrpt 100