PLANET WGSW-52040 - Manual (Page 863)

63-403
Command mode:
Admin Mode
Usage Guide:
The show running-config command differs from show startup-config in that when the user finishes a set of
configurations, show running-config displays the added-on configurations whilst show startup-config won’t
display any configurations. However, if write command is executed to save the active configuration to the Flash
memory, the displays of show running-config and show startup-config will be the same.
63.21 show switchport interface
Command:
show switchport interface [ethernet <IFNAME>]
Function:
Show the VLAN port mode, VLAN number and Trunk port messages of the VLAN port mode on the switch.
Parameter:
<IFNAME> is the port number.
Command mode:
Admin mode
Example:
Show VLAN messages of port ethernet 1/1.
Switch#show switchport interface ethernet 1/1
Ethernet1/1
Type :Universal
Mac addr num : No limit
Mode :Trunk
Port VID :1
Trunk allowed Vlan :ALL
Displayed Information Description
Ethernet1/1 Corresponding interface number of the Ethernet.
Type Current interface type.