2 setting the jog speed – Yaskawa SGDB User Manual
Page 113
Advertising
3.3 Setting Up the Σ SERVOPACK
101
3.3.2 Setting the Jog Speed
Use the following parameter to set or modify a motor speed when operating the Σ-series
Servo from a Digital Operator:
Cn-10
JOGSPD
Jog Speed
Unit:
min
−1
Setting
Range: 0
to 10000
Factory
Setting:
500
For Speed/Torque
Control and Position
Control
This parameter is used to set a motor speed when
the motor is operated using a Digital Operator.
If a value higher than the maximum speed is set,
the maximum speed value is used.
3
Operation Using Digital Operator
Advertising