8 checking software version – Yaskawa SGDB User Manual
Page 227
Advertising
USING THE DIGITAL OPERATOR
4.2.8 Checking Software Version
216
4.2.8 Checking Software Version
This mode is used for maintaining the motor.
When Cn-00 is set to 00-06, this mode is used to check the software version.
Use the following procedure to check the software version.
Hand-held Digital Operator
1. Set Cn-00 to 00-06.
2. Press the DSPL/SET Key.
The software version is displayed.
Software Version Display
Type
b: Type SGDB-jADj
Software
Version
Checking of the software version has now been completed.
Mounted Digital Operator
1. Set Cn-00 to 00-06.
2. Press the MODE/SET Key.
The software version is displayed.
3. Press the MODE/SET Key.
The software version is displayed.
Checking of the software version has now been completed.
4
Advertising