Yaskawa SGDB - Manual (Page 43)

Molded-case circuit
breaker (MCCB)
Used to protect
power supply
line. Shuts the
circuit off if
overcurrent is
detected.
Noise filter
Used to eliminate external
noise from power supply
line.
Magnetic contactor
Turns the servo
ON or OFF.
Use a surge
suppressor for
the magnetic
contactor.
Brake power supply
Used for
servomotor
with brake.
Types:
LPSE-2H01 (for 200 V input)
LPDE-1H01 (for 100 V input)
Allows the user to set parameters or operation
references and display operation status or
alarm status. The following two types are
available in addition to personal computers:
Digital Operator
Hand-held type
(JUSP-OP02A-1)
1-meter(3.3ft.)
cable included
Personal computer
1CN connector kit
Connector terminal block conversion unit
Cable with 1CN connector and
one end without connector
Host controller
SERVOPACK is compatible with most P.L.C.
motion controllers and indexers.
Cable for PG
Connector for
PG
Regenerative resistor unit
If the capacity of the regenerative resistor
is insufficient, remove the internal resistor
(P-B terminals) and connect it to the P-B
terminals).
For SERVOPACK with capacity more
than 6kW, a regenerative resistor unit is
mounted separately (connected to P1-B
terminals)
See next page
Power supply
3 phase 200 VAC
Molded-case
circuit breaker
Noise filter
Magnetic
contactor
Magnetic
contactor
Regenera-
tive resistor
(option)
Brake
power supply
See next page
Types:
LF-350
LF-315
LF-320
LF-380K
Power
ground
Mount type (JUSP-OP03A)
This type can be mounted
directly on the SERVOPACK.
MP920
Connecting cable type:
DE9405258
2.3 Connection and Wiring
31
2