Yaskawa SGDB User Manual
Page 523
INSPECTION, MAINTENANCE, AND TROUBLESHOOTING
6.2.1 Troubleshooting Problems with Alarm Display cont.
514
J
A.82
Display and Outputs
Digital Operator
Di l
d
Alarm Output
g
p
Display and
Alarm Name
Alarm Code Output
Alarm Output
Alarm Name
ALO1
ALO2
ALO3
p
A.82
Absolute encoder
sum-check error
(only when 12 bit
absolute encoder
is used)
OFF
OFF
OFF
OFF
OFF: Output transistor is OFF
ON: Output transistor is ON
Status When Alarm Occurred
B
At power ON
Cn-01 Bit 1 = 0
Cn-01 Bit 1 = 1
When SEN signal turned
ON, Cn-01 Bit 1 = 0
A
, B
A
During operation
(see note)
A
Cause
Remedy
A
Abnormality during absolute encoder
memory check
• Follow absolute encoder set-up proce-
dures.
• Replace servomotor if error occurs fre-
quently.
B
Circuit board (1PWB) defective
Replace SERVOPACK.
Note
An absolute encoder error (A.80) is given initially if a sum-check error (A.82) is generated
during operation.
The sum-check error (A.82) occurs after turning the SEN signal (or SERVOPACK power sup-
ply) OFF and back ON.
However, the sum-check error (A.82) does occur during operation if the host controller is re-
ceiving the S-phase signal (serial data).
6