Basler Electric BE1-700 - Manual (Page 107)

Function Range/Purpose Default
RI OR logic term to initiate the operation of the reclosing function. V08
STATUS
OR logic term to indicate breaker status.
TRUE/1 = closed, FALSE/0 = open.
/IN1
WAIT OR logic term to momentarily disable but not reset the recloser. VO12
BLK/DTL OR logic term to disable the recloser (drive to lockout). VO9
PI OR logic term to initiate the operation of the pilot function. 0
Operating Settings for Reclosing
Operating settings are made using BESTCOMS. Figure 4-50 illustrates the BESTCOMS screen used to
select operational settings for the reclosing element. To open the screen, select Reclosing from the
Screens pull-down menu. Alternately, settings may be made using the S<g>-79 ASCII command.
Settings can also be made from the front panel HMI using Screens 5.x.11.1 through 5.x.11.5 where x
equals 1 for Setting Group 0 and 2 for Setting Group 1.
Figure 4-50. Reclosing Screen
At the top of the screen is a pull-down menu labeled Logic. This menu allows viewing of the BESTlogic
settings for each preprogrammed logic scheme. A custom logic scheme must be created and selected in
the Logic pull-down menu at the top of the screen before BESTlogic setting can be changed. See Section
7, BESTlogic Programmable Logic. To the right of the Logic pull-down menu is a pull-down menu labeled
Settings. The Settings menu is used to select the setting group that the element’s settings apply to.
Selecting the time units selects the time measurement that applies to all of the reclosing timers, Reset
timer, Max Cycle timer, Reset Fail timer, and Pilot timer.
Using the pull-down menus and buttons, make the application appropriate settings to the reclosing
function.
Figure 4-30 summarizes the operating settings for Reclosing.
9376700990 Rev M BE1-700 Protection and Control 4-51