Basler Electric BE1-700 - Manual (Page 363)

HMI Display
This tab (Figure 14-9) allows the user to view what would be shown on the BE1-700's HMI display as the
UP, DOWN, LEFT, and RIGHT push buttons are clicked. These displays are similar to Figures 10-2
through 10-9 in Section 10, Human-Machine Interface. Notice, too, that the corresponding screen number
is shown in the right pane. The user is also able to change the screen scroll list from the right pane. Be
aware that only the code for the latest version of BESTCOMS is contained within BESTCOMS. If you
have an earlier version of the embedded firmware in your relay and select information on the General
Information tab under General Operation screen, you might select a screen scroll item in BESTCOMS
that is not available in the relay. If you do, you will immediately get an error code.
Figure 14-9. General Operation Screen, HMI Display Tab
Conversions
The Conversions tab brings up the screen that allows entries in per unit quantities. See Figure 14-10. The
per unit conversion for the settings involves entries for the Base quantities. When you are entering
settings later on, you can select primary current values, secondary current values, percent, or per unit
values. If you are using percent or per unit, then you have to enter the Conversion screen field values
regarding three-phase, phase-to-phase, and phase-to-neutral base quantities. If the settings are entered
in terms of primary or secondary current values, you do not need to enter this information.
9376700990 Rev M BE1-700 BESTCOMS Software 14-9