Basler Electric BE1-700 - Manual (Page 380)

Outputs 1 - 5, A
On this tab (Figure 14-32); the only feature that you may change is to select the programmable hold
attribute. To select the hold attribute (contacts remain closed for 200 milliseconds) for any output, click on
the Hold Attribute field for that output. To change the label for any of the virtual outputs, see the
paragraphs on BESTlogic, Virtual Outputs, later in this manual.
Figure 14-32. Inputs and Outputs Screen, Outputs 1-5, A Tab
Virtual Switches
Pull down the Screens menu and select Virtual Switches or click on the Virtual Switches icon,
which is shown at the right margin of this paragraph. This screen (Figure 14-33) has no folder
tabs and is labeled Virtual Switches.
Virtual Switches (x43 & 101)
You can assign a meaningful name or label to each of the two virtual switches (Figure 14-33). This makes
sequential events reports easier to analyze. To assign a meaningful label to Virtual Switch 43, click in the
Label field and enter the new name. To change the label for the True State, click on the True State field
and enter the new name. To change the label for the False State, click on the False State field and enter
the new name.
The mode logic setting for Virtual Switch 43 can be made by clicking on the BESTlogic button and, with
your custom logic selected, select the mode logic by using the Mode pull-down menu. The 143 Virtual
Switch has the same functions.
The Virtual Breaker Control Switch (101) provides manual control of a circuit breaker or switch without
using physical switches and/or interposing relays. The mode logic setting for Virtual Breaker Control
Switch 101 can be made by clicking on its associated BESTlogic button and, with your custom logic
selected, select the mode logic by using the Mode pull-down menu. Trip outputs include Trip, Close, and
Slip Contact.
14-26 BE1-700 BESTCOMS Software 9376700990 Rev M