Basler Electric BE1-700 - Manual (Page 7)

BESTCOMS
™ Software
Version and Date Change
2.05.00, 05/14 • Corrected settings file upload issue for 127P time delay.
• Added Windows 8 compatibility.
2.04.01, 10/11
• Improved Settings Compare function.
2.04.00, 04/11 • Added Windows® 7 32-/64-bit compatibility and removed Windows
2000 compatibility.
• Improved operation when regional parameters are set to French.
2.03.02, 09/09 • Added option “5” power supply type to style chart.
• Improved Settings Compare function.
• “>” character can now be entered in setting name descriptions.
• Corrected overflow error when too many characters are entered for
time delays on the Voltage and Power Protection screens.
2.03.01, 12/07 • Improved Modbus TCP Discovery program.
• Improved BESTCOMS metering functions.
• Changed pickup setting range of 81 function.
• Changed default nominal frequency range.
2.02.00, 09/04 • Added support for the Modbus/TCP protocol.
• Added links on the System Summary screen to jump to the Settings
screen for the selected setting.
• Revised the 47N Mode label to be Vpn always.
• Added the ability to double click a saved IP address to connect to it.
2.01.00, 07/04 • Provided support for voltage relays (BE1-700V).
• Resolved a possible program crash when using the Discovery applet.
2.00.00, 06/04
• Initial release
Application Firmware
Version and Date Change
2.03.02, 06/14 • Added serial number to fault reports and sequence of events.
• Corrected access timeout operation.
• Corrected 62 logic timer operation when td2 is set less than 8 ms.
• Corrected 60FL operation that caused 60FL to be disabled when
power is cycled.
• Corrected password setting for Modbus over RS485.
• Corrected sample rate in Comtrade files.
• Made fault trigger logic input edge triggered.
• Corrected operation that caused intermittent loss of sync output.
2.03.01, 09/09
• Changed 79 Pilot Reclose functionality so that if the recloser is in
reset, and if the time delay for the pilot reclose is non-zero, and if the
1
st reclose time delay is set to zero, then upon a trip, a reclose initiate
will cause the relay to use the 2 nd reclose time delay as the 1 st reclose
time delay.
• Disabled recloser Timing Fail message to front panel HMI when the
recloser fail timer TD=0.
• Corrected 25VM logic “Live Phase/Dead Aux” for AB, BC, and CA
connections.
• Fixed invalid pointer so that screens are properly added to the screen
scroll list.
9376700990 Rev M BE1-700 Introduction v