H3C Technologies H3C SecPath F1000-E - Manual (Page 107)

82
Figure 52 MSTIs corresponding to different VLANs
Configuring MSTP at the CLI
Spanning tree configuration task list
Before configuring a spanning tree, you must determine the spanning tree protocol to be used (STP, RSTP,
or MSTP) and plan the device roles (the root bridge or leaf node).
Complete the following tasks to configure STP:
Task Remarks
Configuring the root
bridge
Setting the spanning tree mode
Required.
Configure the device to work
in STP-compatible mode.
Configuring the root bridge or a secondary root
bridge
Optional.
Configuring the device priority Optional.
Configuring the network diameter of a switched
network
Optional.
Configuring spanning tree timers Optional.
Configuring the timeout factor Optional.
Configuring the maximum port rate Optional.
Configuring the mode a port uses to recognize/send
MSTP packets
Optional.
Enabling the spanning tree feature Required.