H3C Technologies H3C SecPath F1000-E - Manual (Page 141)

116
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VT interface and
enter its view.
interface virtual-template number N/A
3. Configure the local device to
authenticate the peer using
CHAP.
ppp authentication-mode chap
[ [
call-in ] domain isp-name ]
By default, PPP authentication is
disabled.
4. Assign a username to the
CHAP authenticator.
ppp chap user username
The username you assign to the
authenticator must be the same as
the local username you assign to
the authenticator on the
authenticatee.
5. Return to system view. quit N/A
6. Create a local user account
for the authenticatee and
enter local user view.
local-user username N/A
7. Set the password for the local
user. password { cipher | simple }
password
The password of the authenticator
user must be the same as that of the
authenticatee user.
8. Configure the service type of
the local user as PPP.
service-type ppp N/A
9. Return to system view. quit N/A
10. Create an ISP domain, or
enter an existing ISP domain
view.
domain isp-name
Optional.
To configure the ppp
authentication-mode command
with an ISP domain specified
which is not the default domain
system, configure this command
before configuring the ppp
authentication-mode command.
11. Configure local authentication
for the PPP users.
authentication ppp local Optional.
NOTE:
For more information about local user configuration and domain configuration, see Access Control
Configuration Guide.
To configure the authenticatee:
Step Command Remarks
1. Enter system view. system-view N/A
2. Create a VT interface and
enter its view.
interface virtual-template number N/A
3. Assign a username to the
CHAP authenticatee.
ppp chap user username
The username you assign to the
authenticatee here must be the
same as the local username you
assign to the authenticatee on the
authenticator.