H3C Technologies H3C SecPath F1000-E User Manual
Page 521
496
2.
Configure OSPF so that SecPath A and Router C are reachable to each other.
3.
Configure BGP on SecPath A:
# Establish two IBGP connections between SecPath A and Router C.
<SecPathA> system-view
[SecPathA] bgp 100
[SecPathA-bgp] peer 3.0.2.2 as-number 200
[SecPathA-bgp] peer 2.0.2.2 as-number 200
[SecPathA-bgp] quit
# When the two links between SecPath A and Router C are both up, Router C adopts the link
SecPath A<—>Router B<—>Router C to exchange packets with network 1.1.1.0/24. (Set a
higher MED value for route 1.1.1.0/24 sent to peer 2.0.2.2 on SecPath A.)
{
Create ACL 2000 to permit 1.1.1.0/24 to pass.
[SecPathA] acl number 2000
[SecPathA-acl-basic-2000] rule permit source 1.1.1.0 24
[SecPathA-acl-basic-2000] quit
{
Create two route policies, apply_med_50 and apply_med_100. Policy apply_med_50 sets the
MED for route 1.1.1.0/24 to 50. Policy apply_med_100 sets that to 100.
[SecPathA] route-policy apply_med_50 permit node 10
[SecPathA-route-policy] if-match acl 2000
[SecPathA-route-policy] apply cost 50
[SecPathA-route-policy] quit
[SecPathA] route-policy apply_med_100 permit node 10
[SecPathA-route-policy] if-match acl 2000
[SecPathA-route-policy] apply cost 100
[SecPathA-route-policy] quit
{
Apply routing policy apply_med_50 to routes outgoing to peer 3.0.2.2, and apply routing
policy apply_med_100 to routes outgoing to peer 2.0.2.2.
[SecPathA] bgp 100
[SecPathA-bgp] peer 3.0.2.2 route-policy apply_med_50 export
[SecPathA-bgp] peer 2.0.2.2 route-policy apply_med_100 export
# Configure BFD over the link to peer 3.0.2.2 so that when the link SecPath A<—>Router B<
—
>Router C fails, BFD can quickly detect the failure and notify it to BGP, and then the link SecPath
A<—>Router D<—>Router C takes effect immediately.
[SecPathA-bgp] peer 3.0.2.2 bfd
[SecPathA-bgp] quit
4.
Configure BGP on Router C:
<RouterC> system-view
[RouterC] bgp 200
[RouterC-bgp] peer 3.0.1.1 as-number 200
[RouterC-bgp] peer 3.0.1.1 bfd
[RouterC-bgp] peer 2.0.1.1 as-number 200
[RouterC-bgp] quit
5.
Configure BFD parameters (you can use default BFD parameters instead):
# Configure SecPath A.
[SecPathA] bfd session init-mode active
[SecPathA] interface GigabitEthernet0/2