H3C Technologies H3C SecPath F1000-E - Manual (Page 693)

668
Figure 351 Network diagram
Device Interface IP address Device Interface IP address
Source 1 — 10.110.5.100/24 Router B GE0/1 192.168.1.2/24
Source 2 — 10.110.6.100/24 GE0/2 192.168.2.2/24
Router A GE0/1 10.110.5.1/24 SecPath B GE0/1 10.110.3.1/24
GE0/2 10.110.2.2/24 GE0/2 10.110.4.1/24
SecPath A GE0/1 10.110.1.1/24 GE0/3 192.168.2.1/24
GE0/2 10.110.2.1/24 Loop0 2.2.2.2/32
GE0/3 192.168.1.1/24 Loop10 4.4.4.4/32
Loop0 1.1.1.1/32 Loop20 10.1.1.1/32
Loop10 3.3.3.3/32 Router C GE0/1 10.110.6.1/24
Loop20 10.1.1.1/32 GE0/2 10.110.4.2/24
Configuration procedure
1. Configure IP addresses and unicast routing:
Configure the IP address and subnet mask for each interface as per
Figure 351 . (Details not
shown.)
Configure OSPF on the routers and firewalls in the PIM-SM domain to make sure the network-layer
in the PIM-SM domain is interoperable and routing information among the routers and firewalls
can be dynamically updated. (Details not shown.)
2. Enable IP multicast routing, and enable PIM-SM and IGMP:
# Enable IP multicast routing on SecPath A, enable PIM-SM on each interface, and enable IGMP
on the host-side interface GigabitEthernet 0/1.
<SecPathA> system-view
[SecPathA] multicast routing-enable
[SecPathA] interface GigabitEthernet 0/1
[SecPathA-GigabitEthernet0/1] igmp enable
[SecPathA-GigabitEthernet0/1] pim sm
[SecPathA-GigabitEthernet0/1] quit
Loo
p0
Lo
op20
Loop2
0 Loo
p0
G
E
0
/3
G
E
0
/2
G
E
0
/1
G
E
0
/3
G
E
0
/2
G
E
0
/2
G
E
0
/2
G
E
0
/2