Network requirements, Creating a forward-type inline forwarding policy – H3C Technologies H3C SecPath F1000-E User Manual
Page 166
141
Item Description
Port 1
Assign a port to the inline forwarding policy.
Port 2
Assign a port to the inline forwarding policy.
This option is available when the forwarding type is Forward.
Forward-type inline forwarding configuration example in the
Web interface
Network requirements
Packets received on GigabitEthernet 0/1 need to be forwarded from GigabitEthernet 0/2, and packets
received on GigabitEthernet 0/2 need to be forwarded from GigabitEthernet 0/1. Configure
forward-type inline forwarding between GigabitEthernet 0/1 and GigabitEthernet 0/2.
Creating a forward-type inline forwarding policy
NOTE:
Before configuration, make sure that GigabitEthernet 0/1 and GigabitEthernet 0/2 operate in bridge
mode and they are added to zones.
•
Select Network > Forwarding from the navigation tree. Click Add to enter the page for adding an
inline forwarding policy.
Figure 76 Adding a forward-type inline forwarding policy
•
Enter policy ID 1.
•
Select Forward as the policy type.
•
Select GigabitEthernet0/1 from the Port 1 list.
•
Select GigabitEthernet0/2 from the Port 2 list.
•
Click Apply.